[Issue#183] ShuttleXpress + RaspberryPi

#1 – cheton 于 2017-08-05

@kikolobo

ShuttleXpress should be connected to your laptop or desktop computer running browser, you can find the driver at https://www.contourdesign.com/support/drivers/

To configure jog dial, shuttle wheel, and buttons, simply follow the instructions at https://github.com/cncjs/cncjs/wiki/User-Guide#contour-shuttlexpress to specify keyboard shortcuts for your ShuttleXpress.

#2 – AustinSaintAubin 于 2017-08-11

It is possible to make a cncjs pendant with ShuttleXpresss, or to use Node-RED to connect to cncjs web socket and use Node-Red hidstream to make actions based on ShuttleXpress input to the raspberry pi. So you could use any HID device to controller cncjs from the raspberry pi.

#3 – AustinSaintAubin 于 2017-09-15

See cncjs-pendant-keyboard created by @nsfilho
A simple pendant (using wireless keyboard or usb) to CNCJS
Might work with ShuttleXpress or could be made to work with ShuttleXpress.

#4 – kikolobo 于 2017-10-09

Thank you for this!