[LinuxCNC/linuxcnc PR#555] Interp: Clear `offset_map` on subroutine return in MDI About GRBL HAL

Issue #555 | 状态: 已关闭 | 作者: zultron | 创建时间: 2019-02-01

This is a test reproducing #455. After CI is done failing, patch will follow.

#1 – zultron 于 2019-02-01

Ok, after a few tries, these are the results I was looking for:
– [Failure][1] in 8a943f5, the test reproducing the bug
– [Success][2] in a4488d0, the bug fix

Tests pass, ready for review. Thanks!

[1]: https://travis-ci.org/LinuxCNC/linuxcnc/builds/487403640
[2]: https://travis-ci.org/LinuxCNC/linuxcnc/builds/487406774

#2 – andypugh 于 2019-03-10

Thanks

原始Issue: https://github.com/LinuxCNC/linuxcnc/pull/555

评论 (2)