I found this little issue well setting up my pendant and saw the spindle override was always resetting to 1% on first use of the wheel. looks like it was a simple miss when updating these for having multiple spindles.
[LinuxCNC/linuxcnc PR#544] Fix spindle override in halui.cc
-
![[gnea/grbl-Mega Issue#1] $ command extentions](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/5.jpg&h=110&w=185&q=90&zc=1&ct=1)
[gnea/grbl-Mega Issue#1] $ command extentions -
![[gnea/grbl-Mega Issue#2] Better interrupt priorities](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/2.jpg&h=110&w=185&q=90&zc=1&ct=1)
[gnea/grbl-Mega Issue#2] Better interrupt priorities -
![[gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/12.jpg&h=110&w=185&q=90&zc=1&ct=1)
[gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560 -
![[gnea/grbl-Mega Issue#4] Real-time adjustable feedrates](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/11.jpg&h=110&w=185&q=90&zc=1&ct=1)
[gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
- [gnea/grbl-Mega Issue#1] $ command extentions
- [gnea/grbl-Mega Issue#2] Better interrupt priorities
- [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
- [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
- [gnea/grbl-Mega Issue#5] question about the download zip contents
- [gnea/grbl-Mega Issue#6] Adding outputs for external state signals
- [gnea/grbl-Mega Issue#7] which g-code sender is being used in grbl-Mega testing?
- [gnea/grbl-Mega Issue#8] Frecuencia y velocidad de avance.
#1 – andypugh 于 2018-12-19
Yes, looks like an error on my part.