[LinuxCNC/linuxcnc PR#492] Create Spindle_monitor.comp About GRBL HAL

Issue #492 | 状态: 已关闭 | 作者: blazini36 | 创建时间: 2018-08-27

Component to trigger an output based on the commanded vs actual speed of spindle. Useful for triggering E-stop if spindle speed drops below set threshold (cutter jam) to avoid damage.

Required lowpass component to filter spindle-feedback input pin during testing.

Originally written by Andypugh, modified and tested by myself.

#1 – blazini36 于 2018-08-28

I’m not all that familiar with the git process but I believe I committed it to the wrong spot in the directory. Should be in src/hal/components.

Sent from my iPhone

> On Aug 27, 2018, at 1:31 PM, Sebastian Kuzminsky wrote:
>
> Merged #492 into master.
>
> —
> You are receiving this because you authored the thread.
> Reply to this email directly, view it on GitHub, or mute the thread.

#2 – SebKuzminsky 于 2018-08-28

Thanks for the heads up — I should have checked that. I moved the file where it belongs.

原始Issue: https://github.com/LinuxCNC/linuxcnc/pull/492

评论 (2)