About GRBL HAL
  • RP2350 GRBLHAL Control Board
> 未分类 > [LinuxCNC/linuxcnc PR#4] deb: recommend the correct hostmot2 package

[LinuxCNC/linuxcnc PR#4] deb: recommend the correct hostmot2 package

未分类 bolang 4个月前 (10-15) 24次浏览

Issue #4 | 状态: 已关闭 | 作者: SebKuzminsky | 创建时间: 2014-08-25


The correct name for the hostmot2 firmware package to Recommend is
“hostmot2-firmware-all”.

Signed-off-by: Sebastian Kuzminsky seb@highlab.com

原始Issue: https://github.com/LinuxCNC/linuxcnc/pull/4

喜欢 (0)
[LinuxCNC/linuxcnc PR#5] Seb/master/hm2 watchdog [LinuxCNC/linuxcnc PR#3] deb: all flavors recommend hostmot2-firmware-all now
支持作者一杯咖啡
  • [gnea/grbl-Mega Issue#1] $ command extentions
    [gnea/grbl-Mega Issue#1] $ command extentions
  • [gnea/grbl-Mega Issue#2] Better interrupt priorities
    [gnea/grbl-Mega Issue#2] Better interrupt priorities
  • [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
    [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
  • [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
    [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
  • [gnea/grbl-Mega Issue#1] $ command extentions
  • [gnea/grbl-Mega Issue#2] Better interrupt priorities
  • [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
  • [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
  • [gnea/grbl-Mega Issue#5] question about the download zip contents
  • [gnea/grbl-Mega Issue#6] Adding outputs for external state signals
  • [gnea/grbl-Mega Issue#7] which g-code sender is being used in grbl-Mega testing?
  • [gnea/grbl-Mega Issue#8] Frecuencia y velocidad de avance.
Theme by 云落