[LinuxCNC/linuxcnc PR#359] 2.7 About GRBL HAL

Issue #359 | 状态: 已关闭 | 作者: KimK | 创建时间: 2017-11-29

Not sure what’s going on but I think GitHub is way ahead of me, so I’ll just shut up and click.

#1 – jepler 于 2017-11-29

@KimK this pull request does not look right, because it is taking commits from the linuxcnc master branch and requests to add them to 2.7. I’m going to close this one up, and let you open a correct one later.

#2 – KimK 于 2017-11-30

I think this was a mistake, so I’ll close it.

原始Issue: https://github.com/LinuxCNC/linuxcnc/pull/359

评论 (2)