on a trivkins config with kinstype of not both such as sim/axis/lathe that is not homed:
the axes radiobuttons are deselected when any jog stops
using the axes activate keys (XYZA) does not show on the radiobuttons
tested on sim/axis/ lathe, historical_lathe and axis
no ill effects appear on sim/axis/ gantry, ldelta or rdelta
Signed-off-by: Phillip Carter would it be better if the radiobuttons indicated the active axis when a keyboard jog starts rather than when it stops?
![[gnea/grbl-Mega Issue#1] $ command extentions](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/8.jpg&h=110&w=185&q=90&zc=1&ct=1)
![[gnea/grbl-Mega Issue#2] Better interrupt priorities](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/1.jpg&h=110&w=185&q=90&zc=1&ct=1)
![[gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/3.jpg&h=110&w=185&q=90&zc=1&ct=1)
#1 – jepler 于 2017-06-06
@phillc54 thank you for addressing some of my requested changes. Will you have a chance to address the one about the loop over kinsmodule.split() noted here (but for some reason NOT on this page!) https://github.com/LinuxCNC/linuxcnc/pull/261/files/d5055fb92ee1e443effd3c2533865424a941fd8c#r115836906