> 未分类 > [LinuxCNC/linuxcnc PR#140] limit1 & limit2: change params to pins

[LinuxCNC/linuxcnc PR#140] limit1 & limit2: change params to pins

未分类 bolang 4个月前 (10-15) 24次浏览

Issue #140 | 状态: 已关闭 | 作者: jmkasunich | 创建时间: 2016-08-16

The limit value inputs were parameters, but are more
flexible if implemented as pins. The change is pretty
transparent, since setp will set either a param or a
pin. This change was done for limit3 in 2010, just
bringing the other two up to date.

Signed-off-by: John Kasunich jmkasunich@fastmail.fm

原始Issue: https://github.com/LinuxCNC/linuxcnc/pull/140

喜欢 (0)