[LinuxCNC/linuxcnc Issue#99] After Update to 2.7.4 error warning when using “Run From Line” in Gmoccapy About GRBL HAL

Issue #99 | 状态: 已关闭 | 作者: lair82 | 创建时间: 2016-06-30

标签: affects gmoccapy fixed in 2.7 branch

Here are the steps I follow to reproduce the issue:

1. Press Run from line
2. Enter line number you would like to start from, press enter
3. Error pops up
4. Select OK
5. Press “Cycle Start”
6. Machine starts at selected line

This is what I expected to happen:

Machine should start running at selected line

This is what happened instead:

An error pops up, the machine still runs at the selected line, it is just giving this fault when trying to perform the command, here is a screenshot of the fault

#1 – gmoccapy 于 2016-07-11

Has been fixed already in March 2016 (30.03.2016),
so can be closed!

ver. 1.5.6.2
– bugfix: run from line was trying to set an entry in the alarm page, which
I droped in 1.5.6
I cleared the code from unneeded imports and comments

#2 – jepler 于 2016-07-11

@gmoccapy just to confirm, the fix is in 2.7 branch? If so we’ll close this issue when the next 2.7 release is made.

#3 – gmoccapy 于 2016-07-11

Hallo Jeff,

Yes it is in the 2.6, 2.7 and master, it has been fixed with commit
f102b9f118b52346c17a4c3f966327dcf0fc5127

Norbert

Am 11.07.2016 um 13:32 schrieb Jeff Epler:

> @gmoccapy https://github.com/gmoccapy just to confirm, the fix is in
> 2.7 branch? If so we’ll close this issue when the next 2.7 release is
> made.
>
> —
> You are receiving this because you were mentioned.
> Reply to this email directly, view it on GitHub
> https://github.com/LinuxCNC/linuxcnc/issues/99#issuecomment-231709811,
> or mute the thread
> https://github.com/notifications/unsubscribe/AGgE-RihSlMHsSI8TuWpMuNDjUo4fnTiks5qUinagaJpZM4JCFQU.

#4 – jepler 于 2016-07-14

2.7.5 has been released.

原始Issue: https://github.com/LinuxCNC/linuxcnc/issues/99