[LinuxCNC/linuxcnc Issue#60] homing bug in 2.7.4 About GRBL HAL

Issue #60 | 状态: 已关闭 | 作者: SebKuzminsky | 创建时间: 2016-05-05

标签: motion joints-axes affects master

JT reports on IRC:

http://tom-itx.no-ip.biz:81/~tom-itx/irc/logs/%23linuxcnc-devel/2016-05-05.html#15:06:29

< JT-JA13> testing Dewey’s homing branch based on JA and if I set my HOMESEARCHVEL = 0.1 and
my HOMELATCHVEL = 0.05 I get Home switch active before start of latch move
< JT-JA13> I remember Andy saying something once about needing more search velocity for certain
homing
< JT-JA13> So I tried HOMESEARCHVEL = 0.5 and HOMESEARCHVEL = 0.5 and it worked
< JT-JA13> I also tested in 2.7.4
< JT-JA13> just to make sure it was in both

#1 – jepler 于 2016-08-07

There doesn’t seem to be enough information to reproduce this. Is it possible to demonstrate the problem with a (modified) sim config?

#2 – petterreinholdtsen 于 2023-10-03

As no new information has shown up for nine years, I suggest to close this issue.

原始Issue: https://github.com/LinuxCNC/linuxcnc/issues/60

评论 (2)