[LinuxCNC/linuxcnc Issue#545] Electricity go down About GRBL HAL

Issue #545 | 状态: 已关闭 | 作者: IslamMagdy002 | 创建时间: 2018-12-26

the electricity go down during running g code and i want to resume my g code after electricity come

#1 – c-morley 于 2019-01-10

We would need more detail about your issue and ideally a possible solution suggested.
Linuxcnc does have a run-from-line option (some screens hide it by default).
Run-from-line surely is far from good.

This is too vague. Please open again if you can give more information.

原始Issue: https://github.com/LinuxCNC/linuxcnc/issues/545

评论 (1)