im actually looking for the robot arm files which i see this program can be used for but i do not see that specific folder maybe a little pointer please? im looking to control a arm that i made from scratch and diy servos i built as well which is what controls the arm, my arm arent being control manually but autonomous.
评论 (2)
#2 – FrankOcean11 于 2016-02-29
maybe you did not understood, i wasn’t asking you to guide me through configurations. Im asking for the folders containing the source files for the robot arm
![[gnea/grbl-Mega Issue#1] $ command extentions](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/5.jpg&h=110&w=185&q=90&zc=1&ct=1)
![[gnea/grbl-Mega Issue#2] Better interrupt priorities](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/4.jpg&h=110&w=185&q=90&zc=1&ct=1)
![[gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/1.jpg&h=110&w=185&q=90&zc=1&ct=1)
![[gnea/grbl-Mega Issue#4] Real-time adjustable feedrates](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/8.jpg&h=110&w=185&q=90&zc=1&ct=1)
#1 – jepler 于 2016-02-29
The issue tracker is not a location to request help configuring LinuxCNC. The forum at http://forum.linuxcnc.org is a better location.