[LinuxCNC/linuxcnc Issue#268] Axis: can’t change jog speed from keyboard shortcuts About GRBL HAL

Issue #268 | 状态: 已关闭 | 作者: micges | 创建时间: 2017-05-12

Here are the steps I follow to reproduce the issue:

1. Run axis sim config
2. Try to change jog speed from keybard

This is what I expected to happen:

Jog speed changes.

This is what happened instead:

Jog speed doesn’t change.

It doesn’t work in:

2.6.13
2.7.7

#1 – jepler 于 2017-06-09

We discussed this on IRC but didn’t reproduce the problem. Please be more specific in your steps to reproduce. Could it be related to a non-US keyboard layout?

#2 – sphericos 于 2017-11-14

I have noticed the same issue. I have installed a functional system using the stretch iso from here http://www.linuxcnc.org/testing-stretch-rtpreempt/linuxcnc-stretch-uspace-amd64-r9.iso everything was updated and LinuxCNC is version 2.7.-11

After restoring the configuration from another computer, everything functioned as expected with the exception of the jog speed shortcut keys. I assumed that it was a problem with my setup, config or the stretch iso so I followed the guide to build the Linux Mint version including compiling the same version of LinuxCNC from source. Again everything worked as expected except for the jog speed shortcut keys.

I am running a UK keyboard layout but have tried switching to US with no change to the behaviour

#3 – jepler 于 2017-12-10

We believe this was fixed by the commits listed above.

原始Issue: https://github.com/LinuxCNC/linuxcnc/issues/268

Here are the steps I follow to reproduce the issue:

This is what I expected to happen:

This is what happened instead:

It doesn’t work in:

评论 (3)