[LinuxCNC/linuxcnc Issue#179] Incorrect Axis view mode

#1 – SebKuzminsky 于 2016-10-20

I’d like to know what the previous version of 2.8.0 you had was, where things worked right. You can probably see the old version number by running this command:

grep 'upgrade linuxcnc' /var/log/dpkg.log

I’d also like to see your whole config, can you attach your ini file to a comment here?

#2 – jepler 于 2016-10-24

It will probably also be necessary to look at your specific config file. The config files from before the conversion to JA will also be useful to diagnose if the problem turns out to be in the config converter.

I modified the sample config byinterface/parport/stepper-xyza/inch.ini to be sim-only by changing standardpinout.hal as follows:

-loadrt hal_parport cfg="0x0378"
+loadrt sim_parport names=parport.0

and things look like I expect them to.

#3 – phillc54 于 2016-10-25

Oops, I may have led you up the garden path.

I have not used Axis for a while and only did recently after this update
so I may NOT have had the ‘LATHE =’ line in my config previously.

I have just tried on 2.7.7 and it exhibits the same behavior so there
has probably been no change in operation.

Maybe the docs should be changed to reflect the fact that “LATHE =
“ANYTHING” will change the view to lathe.

Sorry about the false alarm.

Cheers, Phill

On 21/10/16 05:46, Sebastian Kuzminsky wrote:

> I’d like to know what the previous version of 2.8.0 you had was, where
> things worked right. You can probably see the old version number by
> running this command:
>
> |grep ‘upgrade linuxcnc’ /var/log/dpkg.log |
>
> I’d also like to see your whole config, can you attach your ini file
> to a comment here?
>
> —
> You are receiving this because you authored the thread.
> Reply to this email directly, view it on GitHub
> https://github.com/LinuxCNC/linuxcnc/issues/179#issuecomment-255193618,
> or mute the thread
> https://github.com/notifications/unsubscribe-auth/ACnoyw4gbKFHuvWgUXw00olTB5ABOB10ks5q17cYgaJpZM4KWeDs.