[LinuxCNC/linuxcnc Issue#123] Linear jog speed slider sets angular axes velocity

Here are the steps I follow to reproduce the issue:

1. Start hexapod-sim, home.
2. Choose A or B or C axis.
3. Jog with + or -.

This is what I expected to happen:

Angular velocity is set with angular jog slider.

This is what happened instead:

Angular velocity is set with linear jog slider.

It worked properly before this:

Not sure.
In my real hexapod machine it works a bit different: after homing/re-homing the first angular jog gets velocity from linear slider, the next is correct.

Information about my hardware and software:

– I am using Debian LinuxCNC ISO
– I am using kernel version 3.4.9-rtai-686-pae #1 SMP PREEMPT Debian 3.4.55-4linuxcnc
– I am running a binary I built myself
– I am using master at 8886d77
– I am using AXIS