[gnea/grbl-Mega Issue#129] Error 22 About GRBL HAL

> > CNC is not trivial and we can’t do this for you:
> > Read the doc and learn Gcode!!!
> > http://linuxcnc.org/docs/html/gcode/g-code.html
>
> No send me some settings for running a CNC and after doing these settings I will change some value according to my setup.

No,
use the GRBL defaultsettings (use $RST command, for more information see https://github.com/gnea/grbl/wiki/Grbl-v1.1-Commands) and then change some values according to your setup.
Learning by doing, that’s what you have do do!

#10 – Shahid-lateef 于 2020-07-24

> > > CNC is not trivial and we can’t do this for you:
> > > Read the doc and learn Gcode!!!
> > > http://linuxcnc.org/docs/html/gcode/g-code.html
> >
> >
> > No send me some settings for running a CNC and after doing these settings I will change some value according to my setup.
>
> No,
> use the GRBL defaultsettings (use $RST command, for more information see https://github.com/gnea/grbl/wiki/Grbl-v1.1-Commands) and then change some values according to your setup.
> Learning by doing, that’s what you have do do!

What is the full command of feed rate I know G93 and G94 is cmd of feed rate but how to set feed rate.
Is G94=F500.0 is a cmd or not

#11 – langwadt 于 2020-07-24

no it is not a command, did you not read the links provided?
G94 alone set the feedrate type to mm(inches) per minute (you don’t need it, it is default unless you have changed it)
F500 alone or at the end of line with a move sets the feed rate to 500mm/minute

#12 – Shahid-lateef 于 2020-07-24

> no it is not a command, did you not read the links provided?
> G94 alone set the feedrate type to mm(inches) per minute (you don’t need it, it is default unless you have changed it)
> F500 alone or at the end of line with a move sets the feed rate to 500mm/minute

Yes I can write these cmd also but error 22 not gone

#13 – langwadt 于 2020-07-24

you posted a screen shot, there is no error22 after F260

#14 – Shahid-lateef 于 2020-07-24

> you posted a screen shot, there is no error22 after F260

That’s only for z axis
X and y axis have an error

#15 – langwadt 于 2020-07-24

try again, you only tried x and y before you set the feedrate

#16 – Shahid-lateef 于 2020-07-24

> try again, you only tried x and y before you set the feedrate

No I tried after setting the feedrate also but shows error 22

#17 – langwadt 于 2020-07-24