[gnea/grbl-Mega Issue#123] Laser connection About GRBL HAL

Issue #123 | 状态: 已关闭 | 作者: winch20010 | 创建时间: 2020-04-16

Hello Gauthier, and thanks for this firmware.
I’m actually trying to moving from repetier to Grbl, and actually, the only issue I have is the laser.

I see in the wiki document different things, and in cpu_map other things…
how can I plug my laser to Grbl ??

in my repetier, it uses to be on Digital 6 in ramps 1.4

in your mega5x pinout diagram, laser is supposed to be on D08 ? (spindle pwn). I don’t see any reference to the laser on this diagram

in the cpu_map you shared, I see :
>>
#define SPINDLEENABLEBIT 3 // MEGA2560 Digital Pin 6
…
#define SPINDLEPWMBIT 4 // MEGA2560 Digital Pin 7
<< which one is for the laser ? thanks in advance for your help Sebastien

#1 – winch20010 于 2020-04-16

#define SPINDLEPWMBIT 4 // MEGA2560 Digital Pin 7
and what does it means ? Digital pin 7 does not exist in RAMPS right ??

#2 – fra589 于 2020-04-16

Hi @winch20010,

You are not on my grbl_Mega-5X version project page, but on the original Mega version…

Warning, you mus use definitions in the #ifdef CPUMAP2560RAMPSBOARD section.
So, the definition is on the line number 384 of the cpu_map.h file :
#define SPINDLEPWMBIT 5 // MEGA2560 Digital Pin 8

@++;
Gauthier.

P.S, close this issue and open another one in https://github.com/fra589/grbl-Mega-5X/issues if you need.

#3 – winch20010 于 2020-04-18

ahah better understand now sorry for the confusion !

原始Issue: https://github.com/gnea/grbl-Mega/issues/123

评论 (3)