About GRBL HAL
  • RP2350 GRBLHAL Control Board
> 未分类 > [Grbl_Esp32 PR#181] Improve affinity with FreeRTOS

[Grbl_Esp32 PR#181] Improve affinity with FreeRTOS

未分类 bolang 4个月前 (10-14) 42次浏览

Issue #181 | 状态: 已关闭 | 作者: odaki | 创建时间: 2019-07-07


Hello Bart-san.

While I was studying FreeRTOS, I found code that seemed to be better corrected.
In particular, calls to vTaskDelayUntil appear to pass uninitialized variables at the first delay call.
Please merge the changes if you decide that this change is reasonable.

Regards.

原始Issue: https://github.com/bdring/Grbl_Esp32/pull/181

喜欢 (0)
[Grbl_Esp32 Issue#182] Error 1 or error 2 when sending commands via serial [Grbl_Esp32 Issue#180] Wall V-Plotter
支持作者一杯咖啡
  • [gnea/grbl-Mega Issue#1] $ command extentions
    [gnea/grbl-Mega Issue#1] $ command extentions
  • [gnea/grbl-Mega Issue#2] Better interrupt priorities
    [gnea/grbl-Mega Issue#2] Better interrupt priorities
  • [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
    [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
  • [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
    [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
  • [gnea/grbl-Mega Issue#1] $ command extentions
  • [gnea/grbl-Mega Issue#2] Better interrupt priorities
  • [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
  • [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
  • [gnea/grbl-Mega Issue#5] question about the download zip contents
  • [gnea/grbl-Mega Issue#6] Adding outputs for external state signals
  • [gnea/grbl-Mega Issue#7] which g-code sender is being used in grbl-Mega testing?
  • [gnea/grbl-Mega Issue#8] Frecuencia y velocidad de avance.
Theme by 云落