Hello,
I have an ESPDuino32. The board is on the following image
!1
What board should I use to compile the firmware?
I am trying to use the following and I get the error you can see
!2
Thank you 
[Grbl_Esp32 Issue#638] What board settings for ESPDuino32 ?
-
![[gnea/grbl-Mega Issue#1] $ command extentions](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/3.jpg&h=110&w=185&q=90&zc=1&ct=1)
[gnea/grbl-Mega Issue#1] $ command extentions -
![[gnea/grbl-Mega Issue#2] Better interrupt priorities](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/1.jpg&h=110&w=185&q=90&zc=1&ct=1)
[gnea/grbl-Mega Issue#2] Better interrupt priorities -
[gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560 -
![[gnea/grbl-Mega Issue#4] Real-time adjustable feedrates](https://www.grblhal.com/wp-content/themes/gitphp/timthumb.php?src=https://www.grblhal.com/wp-content/themes/gitphp/assets/img/pic/9.jpg&h=110&w=185&q=90&zc=1&ct=1)
[gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
- [gnea/grbl-Mega Issue#1] $ command extentions
- [gnea/grbl-Mega Issue#2] Better interrupt priorities
- [gnea/grbl-Mega Issue#3] ATMega16U2 virtual com port on ATMega2560
- [gnea/grbl-Mega Issue#4] Real-time adjustable feedrates
- [gnea/grbl-Mega Issue#5] question about the download zip contents
- [gnea/grbl-Mega Issue#6] Adding outputs for external state signals
- [gnea/grbl-Mega Issue#7] which g-code sender is being used in grbl-Mega testing?
- [gnea/grbl-Mega Issue#8] Frecuencia y velocidad de avance.
#1 – nsiatras 于 2020-10-11
I found out that I need to press the reset button on the board to upload the sketch