[Grbl_Esp32 Issue#229] Motor stop while in middle of gcode running.

#1 – bdring 于 2019-09-24

Do all motors stop at exactly the same time? Can you attach an image of your controller setup?

It might have something to do with your motor enable signal.

#2 – kushalsharma07 于 2019-09-26

Yes all motors stop at the same time. And every time it happens somewhere between 40 to 60%.The gcodes made from Aspire OR Fusion 360, get stuck for some reason
But the gcodes made from Easel.com don’t get stuck. May gcodes from Aspire and fusion contains some unsupported/non recognizable format

#3 – bdring 于 2019-09-26

When you say the browser still shows it running, what do you mean? Does it just say “run” or do you see the xyz values changing.

Does the same file stop at the same place every time?

Can you attach a minimal file that always stops?

#4 – bdring 于 2019-10-03

I am assuming this is a wiring problem…closing