[Grbl_Esp32 Issue#129] Issue to control Grbl_Esp32 with software candle

#1 – gflaser-au 于 2019-04-27

Did you use “unlock” $X command before others?

Try these commands listed here.
https://github.com/gnea/grbl/wiki/Grbl-v1.1-Commands

#2 – sirias52 于 2019-04-28

if you use that option but it does not work…
I’m trying with these programs (https://github.com/bdring/GrblEsp32/wiki/Controlling-GrblESP32),
but I can not make it work

#3 – bdring 于 2019-04-28

I just downloaded Candle and it works fine for me.

#4 – bdring 于 2019-04-30

All of the programs on that wiki page have been tested at some time.

#5 – bdring 于 2019-05-02

I am going to close this issue because it sounds like general serial port issue. I would be happy to help work out the issue over Slack. Request an invite.

#6 – sirias52 于 2019-05-10

Position Type | 1 | Enable MPos:. Disable WPos:

esp32 GRBL default position type is 2