[grbl Issue#1617] does GRBl upport G68 and G69? About GRBL HAL

Issue #1617 | 状态: 已关闭 | 作者: Slixxor | 创建时间: 2020-03-22

Looking at adding some easy auto straightening features to GRBL using a probe. I wondering if it supports G68 and G69 commands?

#1 – Rob2029 于 2020-03-22

I don’t know, but you can try to send the command, with a finger on the E-Stop just in case, if the response is “ok” then it supports the command

#2 – terjeio 于 2020-03-22

G68 and G69 is not supported and neither is G10 L2 with R word, however some senders supports rotation.

#3 – Slixxor 于 2020-03-22

>
>
> G68 and G69 is not supported and neither is G10 L2 with R word, however some senders supports rotation.

Thanks for that. Do you know which senders support it?

#4 – terjeio 于 2020-03-23

At least GRBL-Plotter claims to do so. Never tested it though.

评论 (4)