[grbl Issue#1261] problem with y axis

#1 – chamnit 于 2017-07-14

That’s pretty vague and there are a lot of things that could be wrong. Check your wiring and if your stepper driver not setup with the right current or lots of friction in your y-axis. This is not a problem related to Grbl. Closing.

#2 – samik648 于 2017-07-14

when i connect x axis dir and step to each x and y axis motor driver and motor,both motor are moving.
but when i connect y axis dir and step to each x and y axis motor driver and motor,both motor are not moving

#3 – vMeph 于 2017-07-14

Check the wings of motor if they connected correctly

#4 – jringling 于 2019-01-02

Can I comment here? I have the same problem, no y axis movement. Swapped cables, driver boards, and verified motor is working. Grbl 1.1z on a bachinmaker nano board.

#5 – whitetd 于 2019-01-02

Didable end stops, does it work then?

On Tue, Jan 1, 2019, 7:42 PM jringling

> Can I comment here? I have the same problem, no y axis movement. Swapped
> cables, driver boards, and verified motor is working. Grbl 1.1z on a
> bachinmaker nano board.
>
> —
> You are receiving this because you are subscribed to this thread.
> Reply to this email directly, view it on GitHub
> <https://github.com/grbl/grbl/issues/1261#issuecomment-450782610>, or mute
> the thread
> <https://github.com/notifications/unsubscribe-auth/ACc-k8CL9V29PId-Nx4vq8DCn8eHRcz4ks5u_CqpgaJpZM4OYP2D>
> .
>

#6 – jringling 于 2019-01-02

I can find the limit settings, but not “end stops”. Which line is the y axis end stop?