[grbl Issue#1006] M5 M0 Command not being accepted GRBL 9g About GRBL HAL

Issue #1006 | 状态: 已关闭 | 作者: Phoenix0805 | 创建时间: 2016-06-01

I’ve been battling with the M5 M0 command as the machine would stop, but not stop the spindle. I tried different permutations until I found G0 M5 M0 worked. Still need to upgrade the firmware to the latest and then will retest the command. Just thought I’d share.

#1 – foto-boss 于 2016-08-13

#2 – chamnit 于 2016-09-03

Works in v0.9j.

#3 – evirgenfurkan 于 2017-05-14

i tried v0.9g, v0.9i, v0.9j and v1.1, spindle enable pin output always 5V, M5 not working. I used 1 year, it works but its broke, i dont understood.

#4 – lalo-uy 于 2017-05-14

if you migrate fron 0.8 be aware of pin 11 & 12 swap on V0.9 onwards.

2017-05-14 7:42 GMT-03:00 armozy :

> i tried v0.9g, v0.9i, v0.9j and v1.1, spindle enable pin output always 5V,
> M5 not working. I used 1 year, it works but its broke, i dont understood.
>
> —
> You are receiving this because you are subscribed to this thread.
> Reply to this email directly, view it on GitHub
> <https://github.com/grbl/grbl/issues/1006#issuecomment-301304061>, or mute
> the thread
> <https://github.com/notifications/unsubscribe-auth/AK4bcT01zgSuqiCe2Nc8TfMFHkolpwgLks5r5tqzgaJpZM4IrQKQ>
> .
>

原始Issue: https://github.com/grbl/grbl/issues/1006

评论 (4)